Design and analysis of a new type and normally open hydraulic chuck

Authors

  • Yanfu Li State Key Laboratory of Coal Mine Safety Technology Coal Technology and Engineering Group Shenyang Research Institute Shenyang Coal Science Research Institute Co., Ltd.

DOI:

https://doi.org/10.18063/cse.v4i1.1140

Keywords:

Drilling rig, normally open, hydraulic chuck, design, finite element

Abstract

To solve the problem that large torque drilling rig requires high performance of the chuck, this paper introduces the composition and working principle of a normally open hydraulic chuck, as well as the design and calculation method of its bearing capacity and clamping force. Through the use of creo2.0/simulate finite element analysis module, finite element analysis is made on the main structure parts of the chuck. The results show that the parameter selection and structure design of the chuck mechanism meet the requirements of use, which provides a guarantee for improving the reliability of the chuck mechanism and the overall performance of the drilling rig.

References

Shi Z, Hu S, Yao N. New technology of gas extraction (drainage) and drilling in coal mine. Beijing: Coal Industry Press; 2008: 1-2.

Li H, Zhang L. Discussion on design of hydraulic chuck for power head of full hydraulic tunnel drill. Coal Engineer 1998; (2): 30.

Chang J, Yao K, Fan D. Development of the open type compound gripper on the top of the directional long hole tunnel drilling rig in coal mine. Coal Mine Machinery 2011; 32(7): 148. doi: 10.3969/j.issn.1003-0794.2011.07.069.

Shi L. Design and simulation of 12000 Nm power head of all hydraulic tunnel drilling rig. Xi'an: Xi'an University of Science and Technology 2012; 10. doi: 10.7666/d.d223829.

Zhou Y. Working principle of hydraulic chuck and design of its main parameters. Equipment for Geotechnical Engineering 2011; 12(1): 17-22. doi: CNKI:SUN:DZZB.0.2011-01-019.

Cheng D. Handbook of mechanical design (Volume 2, 5th Edition). Beijing: Chemical Industry Press; 2007: 5-66.

Hu R, Liu C. Creo Parametric 3.0 dynamics and finite element analysis from introduction to mastery. Beijing: Mechanical Industry Press; 2017: 98-122.

Cheng D. Handbook of mechanical design (Volume 1, 5th Edition). Beijing: Chemical Industry Press; 2007: 3-32.

Yao Y, Yao N, Peng T. Design and analysis of the clamping mechanism of the soft coal seam casing drilling rig. Coal Science and Technology 2013; 41(6): 75-76. doi: CNKI:SUN:MTKJ.0.2013-06-018.

Xu S. Finite element method in mechanical design. Beijing: Higher Education Press; 1992: 122-138.

Downloads

Published

2020-01-21

Issue

Vol 4, No 1 (Published)

Section

Original Research Articles

License

Authors contributing to Whioce Publishing Pte. Ltd. agree to publish their articles under the Creative Commons Attribution-Noncommercial 4.0 International License, allowing third parties to share their work (copy, distribute, transmit) and to adapt it, under the condition that the authors are given credit, that the work is not used for commercial purposes, and that in the event of reuse or distribution, the terms of this license are made clear.