About the Journal

Focus and Scope

Materials Science: Materials Review is an international Open Access journal that focuses on all areas of materials science into a single and unique reference source. This is a cross-disciplinary journal to publish original full research articles, reviews, rapid communications, and letters of important technical and scientific findings from fundamental point of view of materials science research.

This journal publishes the most significant new research of experimental and theoretical studies which focus on the synthesis, characterization, properties of materials such as metals, non-metals, metal-oxides, ceramics, glasses, polymers, composites, solids, semiconductors, and electronic materials. Topics are not limited to application of materials as optical materials, superconductors, thin-films, porous materials, nanomaterials and their structures. In addition, the reports of materials with mechanical, magnetic, thermal, biomedical and biological properties are also invited.

Peer Review Process

All manuscripts submitted to Whioce Publishing Pte. Ltd. will follow the following procedure: 

  1. Initial submission are reviewed by in-house editors to ensure adherence to journal policies
  2. Editor-in-chief decides on the manuscript to be sent out for review process and assigns the manuscript to one of the editors according to the particular topic.
  3. Editor assigns reviewers from inside the editorial board or outside depending on the topic.
  4. After evaluations by the reviewers have been received, the editor-in-chief makes one of the following recommendations: accept, minor revision, major revision, reject and resubmit, and reject. Unless otherwise requested by the Editor-in-Chief, the following time frames will be used.
  5. If decision is “minor revision”, the authors have 4 weeks to resubmit the revised manuscript.
  6. If decision is “major revision”, the authors have 2 months to resubmit the revised manuscript.
  7. Upon resubmission, the same procedure is applied as for the initial submission.
  8. Authors may appeal for a rejected submission. Appeal requests must be made in writing to editorial@whioce.com with detailed reasons for the appeal and point by point responses to the reviewer’s remarks. Decisions on appeals are final without exception.
  9. For all manuscripts accepted for publication, the peer review process will be deemed to be completed. The manuscript will proceed to be copyedited, layout edited and proofread before being published online.
Note: You may suggest up to four academically qualified reviewers for consideration. Please insert the current contact details of the reviewer and state the reason(s) for recommendation under the "Comments for the Editor" section. However, please take note that the Editorial team strives to ensure the peer review process is fair and unbiased and hence, there is no guarantee that a recommended reviewer will be approached to perform the peer review.

Publication Frequency

irregular

Open Access Policy

This journal provides immediate open access to its content on the principle that making research freely available to the public supports a greater global exchange of knowledge.

Recently Published Articles

Open Access Original Research Article
Photovoltaic power generation system
by Huanhai Huang, Xiuli Ding, Lingwei Tong
Mater Sci Mater Rev, 1(1). 2017.
Abstract
The potential crisis of energy and the deterioration of ecological environment make the world's cumbersomedevelopment of renewable energy including new energy, including solar energy. Traditional energy in the coal, oil andnatural gas are evolved from anc…

Open Access Original Research Article
Polyethylene plastic production process
by Xiuhua Zhong, Xudong Zhao, Yongkang Qian, Yan Zou
Mater Sci Mater Rev, 1(1). 2017.
Abstract
Polyethylene has become the most important polyolefi n plastic with excellent mechanical properties, processingproperties and chemical resistance. It is used in the production of film, packaging and pipe. However, the nonpolarproperty and low rigidity of …

Open Access Original Research Article
Preparation and Study of Waterborne Asphalt Pavement Maintenance Agent
by Chunfei Yuan, Qinglai Song, Ningning Zhao
Mater Sci Mater Rev, 1(1). 2017.
Abstract
The precursor Ni0.76Co0.1Mn0.1 (OH) 2 was prepared by coprecipitation method. The precursor was mixed withMg (OH) 2 / Zn (NO3) 2 / TiO2 and LiOH.H2O, Li2CO3 to synthesize doped lithium Ion layer positive electrodematerial Li [Ni0.8-xCo0.1Mn0.1Mx] O2 (x = …

Open Access Original Research Article
Study on fl ame retardant ABS
by Xiaonan Lin, Wenmin Feng, Liangzhu Xu
Mater Sci Mater Rev, 1(1). 2017.
Abstract
Flame-retardant ABS resin was prepared by adding fl ame retardant, toughening agent and dispersing silicone oilwith acrylonitrile-butadiene-styrene resin (ABS, grade 0215 A) as raw material. The results showed that in the ABSresin, fl ame retardant with t…

Open Access Original Research Article
The development of polyurethane
by Yanping Ye, Qingxuan Zhu
Mater Sci Mater Rev, 1(1). 2017.
Abstract
Polyurethane is one of the six promising synthetic materials in the world. Due to its excellent product performanceand wide application field, it is a crucial industry of development in the world. This paper introduces the progressof polyurethane industry…

Editorial Board

Editor-in-Chief

V. Gunasekaran, Solid State Electronics Lab, Research Institute of Electrical Communication, Tohoku University, Katahira, Japan

Editorial Board

Adnan Shahid Khan, Faculty of Computer Science And Information Technology (FCSIT), Universiti Malaysia Sawarak (UNIMAS), Malaysia
Aman Jantan, Computer Sciences, Universiti Sains Malaysia, Malaysia
Ismail Ahmedy, Computer System And Technology(Fcsit), University of Malaya, Malaysia
Nadir Shah, Computer Science, COMSATS Institute of Information Technology, Wah Campus, Pakistan
Shahbaz Akhtar Abid, Computer Science, COMSATS Institute of Information Technology, Wah Campus, Pakistan
Zurina Mohd Hanapi, Communication Technology and Network, Universiti Putra Malaysia, Malaysia

Editor-in-Chief

V. Gunasekaran

Plagiarism

The editorial team does not approve of any plagiarism attempts. Plagiarism detection software will be utilized at the editor’s discretion to verify the originality of submitted manuscripts. If plagiarism is detected during the review process the manuscript may be rejected depending on the severity of plagiarism. Therefore, if a manuscript uses a text copied directly from another source, this text must be written in quotation marks and the original source must be cited.

Publication Fees

The publication fees for each manuscript accepted for publication is USD 800 for 6 pages. This fee is meant to support the open access journal’s associated expenses. The editorial team will have the right to assume that authors submitting their manuscripts for publication consents to paying the publication fee upon acceptance for publication unless given a written waiver from both the Editor-in-Chief and the Publisher.

Language

All articles should be written in English—either British or American as long as consistency is observed. SI units should be used. If you are not a native English speaker, you may want to utilize an external or Whioce Publishing’s optional professional language editing service before submitting the final version.

Language Editing Services

Whioce Publishing Pte Ltd offers its own professional editing services. By using this service, you can be sure that your English-language manuscript will be polished and ready for submission to your publication of choice at a very reasonable price. For further details about the Language Editing Services, please contact us at academic@whioce.com. Please note that utilizing a language editing service is not a guarantee of acceptance.

Submission of Revised Manuscripts

Revised manuscripts must contain a detailed point by point response to the comments of the reviewers. The response to reviewers has to be uploaded as a separate file.

Withdrawal of Manuscript

If you withdraw your manuscript after it has been accepted (but not yet published), you will be charged for costs incurred at USD200.

Supporting Information

Authors are expected to have minimal amount of post-acquisition processing of data. In case of processing, alterations must be applied to the entire image (e.g., brightness, contrast, color balance). Any kind of alteration if being done has to be clearly stated in the figure legend and in the Materials and Methods section. Grouping of data (e.g., cropping of images of removal of lanes from gels and bolts) must be made apparent and should be explicitly indicated in the appropriate figure legends. Data comparisons should only be made from comparative experiments, and individual data should not be utilized across multiple figures. If inappropriate image/data manipulation is identified after publication, we reserve the right to ask for the original data and, if that is not satisfactory, to issue a correction or retract the paper as appropriate.

Indexing and Archiving

Materials Science: Materials Review(MSMR) aims to be indexed by world-recognized databases, for example, PubMed, Scopus and Science Citation Index (SCI). MSMR has been indexed and archived by several databases: