Study on flame retardant ABS

Authors

  • Lin Xiaonan

DOI:

https://doi.org/10.18063/msmr.v1i1.506

Abstract

Flame-retardant ABS resin was prepared by adding fl ame retardant, toughening agent and dispersing silicone oil
with acrylonitrile-butadiene-styrene resin (ABS, grade 0215 A) as raw material. The results showed that in the ABS
resin, fl ame retardant with tetrabromobisphenol A and antimony trioxide as the composite system (the mass ratio of
2:1) was added. When the bromine content of the system was more than 10%, the flame retardant ABS meets the
requirements of UL 94 V-0. The best toughening agent for flame retardant ABS resin is ABS graft powder. When
the amount of fl ame retardant ABS is 9% ~ 19% (mass fraction) Strength of 150-200 J / m; in the same formula and
operating conditions, brominated alkylene oxide as fl ame retardant prepared fl ame retardant ABS resin, the weather
resistance is better than tetrabromobisphenol A as fl ame retardant The Composite expansion fl ame retardant and coated
red phosphorus is an eff ective halogen-free fl ame retardant.

Downloads

Published

2018-06-12

Issue

Vol 1, No 1 (Published)

Section

Original Research Articles

License

Authors contributing to Whioce Publishing Pte. Ltd. agree to publish their articles under the Creative Commons Attribution-Noncommercial 4.0 International License, allowing third parties to share their work (copy, distribute, transmit) and to adapt it, under the condition that the authors are given credit, that the work is not used for commercial purposes, and that in the event of reuse or distribution, the terms of this license are made clear.